Owner's manual

System Diagnostics
23
Banner Engineering Corp. • Minneapolis, U.S.A.
Website:http://www.baneng.com • Tel:888.373.6767
5. System Diagnostics
Systemdiagnosticsmaybeperformedusingthestatusanddiagnosticsindicatorsonthe
controlmoduleandsensors.
5.1 Diagnostics/Status Indicators
NOTE:Statusindicatorsappearto“freeze”ifthecontrollerisconfiguredforGateorHost
mode(Section4.4),andnosignalispresenttocauseascanupdate.
Bright,easy-to-seeLEDindicatorsonbothsensorsandonthefrontpanelofthe
controlmoduleprovideanongoingdisplayofthesystem’soperatingstatus.
Control Module:
Output(steadyred)indicatesOutput#1energized.
Alarm (flashingred)indicatesOutput#2energized.Thisoutputmaybeassignedtoan
analysismode,oritmaybeusedasaSystemDiagnosticsalarmorasaTriggeralarm
togateanotherA-GAGEMINI-ARRAYSystem.
Gate(steadyred)displaysthestatusoftheGateinput.
Alignment: (steadygreen)indicatesproperemitter/receiveralignmentandaclear,
unblockedlightscreen.ThisindicatorisONwheneitherthegreenorboththegreen
andyellowLEDsofthereceiverareON.
Diag 1, Diag 2, Diag 3: ThesethreeDiagnosticsindicatorsareusedincombinationto
determineSystemstatus,asshowninthefollowingtable.
Diag 1 (Green) Diag 2 (Red) Diag 3 (Red) Condition
 ON OFF OFF Normaloperation
 ON ON OFF Receivererror
 ON OFF ON Emittererror
 ON ON ON Emitter/receivermismatch
 OFF ON OFF Controllererror
 OFF OFF ON EEPROMerror
 OFF ON ON ROM/RAMerror
Network Status Indicator:Bi-colored(red/green)LEDindicatesnetworkstatus.
Steady Green Online,connectedtoMaster.
Flashing Green On-line,addressandbaudrateOK
Steady Red Criticalnetworkfaultorduplicatenodeaddressdetected
Flashing Red Connectiontimeout
OFF Nonetworkpower,oroffline
Emitter:
Operational(steadyred)LEDindicatespowertotheemitterisON.
Receiver:
Blocked (steadyred)LEDindicatessomeofthearraybeamsareblocked.
Marginal(steadyyellow)LEDindicatesthatarrayalignmentismarginal.
Alignment: (steadygreen)LEDindicatesthatarrayalignmentissatisfactory.
MINI-ARRAY CONTROLLER for DeviceNet
POWER
MACNXDN1
NETWORK
STATUS
1
1
V+
16 - 30V dc
1.2A MAX
EMTR RCVR
+12V
BR BU BK
5 Wires
30V
150mA Max
OUT1
10-30V dc
GATE
30V
150mA Max
ALARM
WH
NC
+–
NC
COM DRN T/R
2 3 4 5 6 7 8 9 10 11 12 13 14 15 D5 D4 D3 D2 D1
V-
F1
T/R
V+
BR BU BK
5 Wires
WH
CAN_HSHIELD V-CAN_L
DIAG1
DIAG2
DIAG3
OUT1 ALARM GATE ALIGN
2 3 4 5 6 7 8 9 10

11
12 13 14 15 16 17 18 19 20

AlignDiag1
Diag2
Diag3
Gate
Alarm
Out1
Figure 5-1. A-GAGE MINI-ARRAY with
DeviceNet System diagnostics
and status indicators