Owner's manual

Installation and Mechanical Alignment
15
Banner Engineering Corp. • Minneapolis, U.S.A.
Website:http://www.baneng.com • Tel:888.373.6767
Mounttheemitterandreceiverintheirbracketsandpositiontheredlensesofthetwo
unitssotheydirectlyfaceeachother.Theconnectorendsofbothsensorsmustpoint
inthesamedirection.Measurefromoneormorereferenceplanes(e.g.thebuilding
floor)tothesamepoint(s)ontheemitterandreceivertoverifytheirmechanical
alignment.Ifthesensorsarepositionedexactlyverticalorhorizontaltothefloor,a
carpenter’slevelisusefulforcheckingalignment.Astraightedgeorastringextended
betweenthesensorsalsohelpswithpositioning.Alsocheck“byeye”forline-of-sight
alignment.Makeanynecessaryfinalmechanicaladjustments,andhand-tightenthe
brackethardware.SeeSection4.2forfurtherinformationonalignment.
3.2 Control Module Mounting
ThecontrolmodulemustbeinstalledinsideanenclosurewhichhasaNEMA(orIEC)
ratingsuitablefortheoperatingenvironment.
MountingdimensionsforthecontrollerareshowninFigure2-2,onpage11.The
controlmoduleissuppliedwithM3.5hardwarefordirectmountingtoasurface,orit
maymountdirectlyontostandard35mmDINrail.
NON-QD EndQD End
Min. R.
Full R (4)
4.8 mm (2)
(0.19")
38.1 mm
(1.50")
6.4 mm R
(0.25")
44.5 mm
(1.75")
6.4 mm
(0.25")
57.2 mm
(2.25")
3.8 mm
(0.15")
10.2 mm (2)
(0.40")
ø30.5 mm
(1.20")
34.8 mm
(1.37")
11.9 mm
(0.47")
Slots have clearance
for M4 bolts (supplied)
and allow ±30° rotation
ø13.2 mm
(0.52")
ø6.8 mm (2)
(0.27")
3.0 mm
(0.12")
24.6 mm
(0.97")
53.8 mm
(2.12")
Material: Cold Rolled Steel
Finish: Black, Zinc Plated
Chromate Dip
Figure 3-2. A-GAGE MINI-ARRAY emitter and receiver mounting bracket dimensions