Owner's manual

Specifications
13
Banner Engineering Corp. • Minneapolis, U.S.A.
Website:http://www.baneng.com • Tel:888.373.6767
Analysis Mode 1 (FBB)
FBB: FirstBeamBlocked
FBM: FirstBeamMade
LBB: LastBeamMade
LBM: LastBeamMade
TBB: TotalBeamsBlocked
TBM: TotalBeamsMade
CBB: ContiguousBeamsBlocked
CBM: ContiguousBeamsMade
Disabled
Analysis Mode 2 (Disabled)
FBB: FirstBeamBlocked
FBM: FirstBeamMade
LBB: LastBeamMade
LBM: LastBeamMade
TBB: TotalBeamsBlocked
TBM: TotalBeamsMade
CBB: ContiguousBeamsBlocked
CBM: ContiguousBeamsMade
Disabled
Scan Control Modes (Continuous)
ContinuousScanning
GateMode
HostMode
Scanning Methods (Straight)
StraightScan
SkipScan1
SkipScan2
SkipScan3
SkipScan4
SkipScan5
SkipScan6
SkipScan7
Interlaced(Dither)Scan
EdgeScan
Output 1 Analysis Mode (Disabled)
 Disabled
AnalysisMode1
AnalysisMode2
Output 1 Set Point – Low (1)
 1-384
Output 1 Set Point – High (1)
 1-384
Output 1 Hysteresis – Low (0)
 0-385
Output 1 Hysteresis – High (2)
 0-385
Output 1 Invert (No)
 No
Yes
Output 2 Analysis Mode (Disabled)
 Trigger
 Alarm
 Disabled
AnalysisMode1
AnalysisMode2
Single Scan (No)
 No
 Yes
Output 2 Set Point – Low (1)
 1-384
Output 2 Set Point – High (1)
 1-384
Output 2 Hysteresis – Low (0)
 0-385
Output 2 Hysteresis – High (2)
 0-385
Output 2 Invert (No)
 No
Yes
Measurement Mode 1 Result (0)
Measurement Mode 2 Result (0)
Output 1 & 2 Scan Number (1)
 1-9
Alignment Status (Unknown)
 0: Made
1: Broken
Number of Beams (0)
 0-384
Beam Status (0)
 0: Brokenornotused
1: Made
Blanking Beams (0)
 0: Notblanked
1: Blanked
Number of Emitter Beams (0)
 0-192
Number of Receiver Beams (0)
 0-192
Status of Controller (Unknown)
 Unknown
EEPROMerror
Controllererror
ROMerror
Normal
Emittererror
Receivererror
Emitter/receivermismatch
(Items in parentheses are Factory Default Settings)