Owner's manual
Specifications
10
Banner Engineering Corp. • Minneapolis, U.S.A.
Website:http://www.baneng.com • Tel:888.373.6767
2.2 Control Module with DeviceNet Specifications
DeviceNet Configurations
Vendor code: 12(BannerCorp.)
Device type: 110
Product code: 1(MACNXDN-1)
2(MACPXDN-1)
Connection types supported: ExplicitMessage,Poll,COS
Network address: 0-63(networkconfigured)
Baud rate supported: 125K,250K,500K(networkconfigured)
Output Configurations
MACNXDN-1:TwoPNPdiscrete(switched)
MACPXDN-1:TwoNPNdiscrete(switched)
Power Requirements*
Controller, emitter and receiver:16to30Vdc@1.2Amax.(typical:0.5A@16Vdc)
Inputs
Sensor input: Emitterandreceiverwireinparalleltofiveterminals.
Gate input:Opticallyisolated,requires10to30Vdc(7.5kΩimpedance)forgatesignal
Discrete (Switched) Outputs
NPN outputs: OpencollectorNPNtransistorratedat30Vdcmax.,150mAmax.
PNP outputs:OpencollectorPNPtransistorratedat30Vdcmax.,150mAmax.
All discrete outputs:
OFF-state leakage current:<10µA@30Vdc
ON-state saturation voltage:<1V@10mAand<1.5V@150mA
System Programming
ViaDeviceNetinterfaceandsuppliedEDSfiles.
System Status Indicators
Output (steady red):Output#1energized.
Alarm (flashing red):Output#2energized.
Gate (steady red):Gateinputstatus.
Alignment (steady green): Properemitter/receiveralignmentandaclear,unblockedlightscreen(ONwhen
greenorgreen/yellowreceiverLEDsareON.
Diag 1 (green), Diag 2 (red), Diag 3 (red): UsedincombinationtodisplaySystemstatus;seeChapter5,
SystemDiagnosticsformoreinformation.
Network Status Indicator
Bi-colored(red/green)LEDvisibleonthecontrolmodulefrontpanelindicatesnetworkstatus:
Steady Green: On-line,connectedtomaster
Flashing Green: On-line,addressandbaudrateOK
Steady Red: Criticalnetworkfaultorduplicatenodeaddressdetected
Flashing Red: Connectiontimeout
OFF: Nonetworkpoweroroff-line
Construction
Polycarbonatehousing;mountstoflatsurfaceordirectlyonto35-mmDINrail
Environmental Rating
NEMA1(IP20)
Operating Conditions
Temperature: -20°to+70°C(-4°to158°F)
Maximum relative humidity:95%@50°C(non-condensing)
DeviceNet Power*
11to25Vdc-suppliedbyDeviceNetBUSNetwork
*Application Note
ThecontrollermustbepoweredupbeforetheDeviceNetconnectionineverypower-upsituation
forproperoperation