Instruction Manual

Action Result
Pulses TEACH Mode
1
T
Speed = Fast
2
T T
T
Speed = Medium
3
T T
T
T
T
Speed = Slow
The speed is set and the power LED flashes
equal to the number of pluses, pauses, and
then flashes equal to the number of pulses a
second time. The sensor exits remote teach
and returns to run mode.
Target Selection Mode
Use Target Selection to set the target that the output sees.
1. Access Target Selection mode.
Action Result
Five-pulse the remote input.
T T
T
T
T
T
T
T
T
The green power LED flashes slowly.
2. Select the desired signal threshold.
Action Result
Pulses TEACH Mode
1
T
Nearest Target—Output responds
to the nearest target that is over
the signal strength threshold.
2
T T
T
Strongest Target—Output
responds to the target with the
highest signal strength that is over
the signal strength threshold.
The signal threshold is set and the green
power LED flashes equal to the number of
pluses, pauses, and then flashes equal to
the number of pulses a second time. Then
the sensor exits remote teach and returns to
run mode
5.4 Push Button Configuration
Using the push buttons, the first and second points can be taught.
This can be done by teaching two separate points or the same point twice. For more information on the Teach modes, see
Remote Setup on page 17. If other changes to the configuration are needed, use either the Banner Radar Configuration
Software or the remote input.
R-GAGE
®
T30R Sensor
www.bannerengineering.com - Tel: + 1 888 373 6767 19
Preliminary