Cut Sheet

The model SMB30A right-angled mounting bracket (not shown)
has a curved mounting slot for versatility and orientation. The
SM30 Series sensor mounts to the bracket using a jam nut (supplied
with the sensor). The curved mounting slot has clearance for 1/4-
inch screws. Bracket material is 11-gauge stainless steel.
The model SMB30S swivel-mount bracket (below, left) offers
the ultimate in flexibility and convenience. This bracket mounts by
its base. The SM30 threads into the adjustable captive "ball" of the
bracket, which locks snugly in position when two clamping bolts
are tightened. Bracket material is black VALOX
®
. Hardware is
stainless steel, and mounting bolts are included.
The model SMB30C split clamp (not shown) mounts to a flat
surface and grips the SM30 sensor by its threaded barrel. This
bracket is similar to the SMB30S, but without the adjustable ball.
SM30 Series sensors may also be mounted in a 30-mm clear-
ance hole, using the supplied jam nuts.
Banner Engineering Corp. 9714 10th Avenue No., Minneapolis, MN 55441 Telephone: [phone] FAX (applications): [phone]
Dimensions, EZ-BEAM SM30 Series sensors
WARRANTY: Banner Engineering Corporation warrants its products to be free from defects for one year. Banner Engineering Corporation will repair or
replace, free of charge, any product of its manufacture found to be defective at the time it is returned to the factory during the warranty period. This warranty
does not cover damage or liability for the improper application of Banner products. This warranty is in lieu of any other warranty either expressed or implied.
Mounting Options for EZ-BEAM S30 Series Sensors
Hookup, SM30 Series EZ-BEAM ac opposed mode sensors (cabled models)
!
WARNING These photoelectric presence
sensors do NOT include the self-checking redun-
dant circuitry necessary to allow their use in person-
nel safety applications. A sensor failure or malfunc-
tion can result in either an energized or a de-
energized sensor output condition.
Never use these products as sensing devices for personnel protection.
Their use as safety devices may create an unsafe condition which could
lead to serious injury or death.
Only MACHINE-GUARD and PERIMETER-GUARD Systems, and
other systems so designated, are designed to meet OSHA and ANSI
machine safety standards for point-of-operation guarding devices. No
other Banner sensors or controls are designed to meet these standards,
and they must NOT be used as sensing devices for personnel protection.
Quick Disconnect fitting adds .35" (9 mm) in overall length to QD models.
QD models require Quick Disconnect cable (order separately; see Specifica-
tions section for information).
SMB30S Swivel Mounting Bracket
Receivers
Emitters
Hookup is
without regard
to wire color.
Sensors with Q1 model suffix require QD (Quick Disconnect)
cable. See Specifications section for information.
NOTE:
Receivers SM30AW3R and
SM30AW3RQ1 are light-
operate. Output conducts when
the receiver sees the emitter's
modulated beam.
Receivers SM30RW3R and
SM30RW3RQ1 are dark-
operate. Output conducts when
the receiver does not see the
emitter's modulated beam.
Any receiver may be paired
with any emitter (SM303E or
SM303EQ1).
Hookup information for QD
sensors is provided with the
sensor.
Excess Gain Curve
Beam Pattern