Cut Sheet

Contacts: Open Closed Transition
Switching Diagram tolerances:
Operating point ± 0.25 mm
Operating force ± 10%
Guard closed (home position) is at 0 mm when mounted
in a positive mode. Note to scale.
Maximum allowable travel varies by model and is listed at
bottom of switching diagram (minus operating tolerance).
Installation must ensure sufficient travel for positive
opening of safety contacts and account for any mechani-
cal tolerances.
The actuator can only approach from the hinge side.
Actuator can be removed and reposition/rotated by 90°
increments. Ensure all screws are properly re-installed.
Max. Approach speed vs. Max. Approach angle
Direction of actuation is perpendicular to the actuating system axis
and only from the hinge side of the actuator. Exceeding specified
approach angle or speed can reduce life expectancy.
20°
0.1 m/s
0.5 m/s
1 m/s
2 m/s
5 m/s
β
20°
β
CAM
Direction of
Actuation
Ø13.5
32.75
4
23
M5(X2)
β
Contact Configuration (Guard Closed State)
SI-LS83LE13D SI-LS83LE13E
10°
0mm
0.7
1.6
1.8
4.6
11 - 12
23 - 24
3.5N
10N
0mm
0.7
1.6
4.6
11 - 12
21 - 22
3.5N
9N
Safety
Safety Safety
Non-Safety
Figure 4. SI-LS83LE13x Switching Diagrams
NOTE: This symbol
for a positive-opening safety contact (IEC 60947-5-1) is used in the switching
diagram to identify the point in actuator travel where the normally-closed safety contact is fully open.
Safety Limit Switches
8 www.bannerengineering.com - Tel: [phone] P/N 182191 Rev. A