Cut Sheet

Laser Descripon and Safety Informaon
CAUTION: Do Not Disassemble for Repair
This device contains no user-serviceable components. Do not
aempt to disassemble for repair. Use of controls or adjustments or
performance of procedures other than those specied herein may
result in hazardous radiaon exposure. A defecve unit must be
returned to the manufacturer.
12.5 mm
(0.49")
16.76 mm
(0.66")
Aperture
Ø 3.76 mm
(0.148")
Figure 12. Laser Aperture Locaon
Class 1 Lasers
Class 1 lasers are lasers that are safe under reasonably foreseeable condions of operaon,
including the use of opcal instruments for intrabeam viewing.
Reference IEC 60825-1:2001, Secon 8.2.
Class 2 Lasers
Class 2 lasers are lasers that emit visible radiaon in the wavelength range from 400 nm to
700 nm, where eye protecon is normally aorded by aversion responses, including the
blink reex. This reacon may be expected to provide adequate protecon under
reasonably foreseeable condions of operaon, including the use of opcal instruments for
intrabeam viewing.
Reference IEC 60825-1:2001, Secon 8.2.
Class 2 Laser Safety Notes
Low-power lasers are, by denion, incapable of causing eye injury within the duraon of a
blink (aversion response) of 0.25 seconds. They also must emit only visible wavelengths (400
to 700 nm). Therefore, an ocular hazard may exist only if individuals overcome their natural
aversion to bright light and stare directly into the laser beam.
Pulse Power < 2.6mW 650-670
nm, 2kHz, 15.5 uS Pulse.
Complies to 21 CFR 1040.01 &
EN60825-1:2001 except for
deviations pursuant to laser
notice No. 50, dated 7-26-01.
CLASS 2
LASER PRODUCT
DO NOT STARE
INT
O BEAM
LASER RADIATION EMITTED
FROM THIS APPERTURE
For Safe Laser Use (Class 1 or Class 2):
•
Do not stare at the laser.
• Do not point the laser at a person’s eye.
• Mount open laser beam paths either above or below eye level, where praccal.
• Terminate the beam emied by the laser product at the end of its useful path.
Q60LAF Series Laser Adjustable-Field Sensors
8 www.bannerengineering.com - Tel: [phone] P/N 114348 Rev. A