Cut Sheet

Retroreflective Targets
Banner offers a wide selection of high-quality retroreflective targets. See
www.bannerengineering.com for complete information.
NOTE: Polarized sensors require corner cube type
retroreflective targets. Non-polarized sensors may use
any retroreflective target.
Brackets
SMB30C
• 30 mm split clamp, black
PBT bracket
• Stainless steel mounting
hardware included
• Mounting hole for 30 mm
sensor
66
56
13
A
B
Hole center spacing: A=ø 45
Hole size: B=ø 27.2
SMB30MM
• 12-ga. stainless steel bracket
with curved mounting slots
for versatile orientation
• Clearance for M6 (¼ in)
hardware
• Mounting hole for 30 mm
sensor
70
57
A
B
C
57
Hole center spacing: A = 51, A to B = 25.4
Hole size: A = 42.6 x 7, B = ø 6.4, C = ø 30.1
SMB30SC
• Swivel bracket with 30 mm
mounting hole for sensor
• Black reinforced
thermoplastic polyester
• Stainless steel mounting and
swivel locking hardware
included
67
58
29
B
A
Hole center spacing: A=ø 50.8
Hole size: A=ø 7.0, B=ø 30.0
Output Timing Logic and Signal Strength Display Modules
Q45 sensors easily accept the addition of output timing logic and signal strength display functions. Display modules have a
seven-element display that gives a more precise indication of excess gain than does the AID
™
system LED that is standard
on Q45 sensors. The modules listed below may be used with all Q45BB6 sensors. Refer to the module's datasheet for more
information.
Models
Logic and/or Display Function
45LM58 Programmable output timing logic
45LM58D Programmable output timing logic plus signal strength display
45LMD Signal strength display only (no timing function)
Q45BB6 Series Sensors
P/N 36578 Rev. E www.bannerengineering.com - Tel: [phone]