Cut Sheet

from Run Mode
Access
Quick Menu
Access
Sensor Menu
See Quick Menu on page 4 See Sensor Menu (MENU) on page 4
Figure 6. Accessing the Menus
Quick Menu
The sensor includes a Quick Menu with easy access to view and change the analog and discrete output switch points. Access the Quick
Menu by pressing Down
or Up from Run mode. When in the Quick Menu, the current distance measurement displays on the
rst line and the menu name and the analog value alternate on the second line of the display. Press Enter to access the switch
points. Press Down and Up to change each digit. Press Enter to move right one digit. Aer reviewing each digit, press Enter again to
save the new value and return to the Quick Menu. Press Cancel to ignore any changes made if only some digits have been changed.
Quick Menu
4mA Pt (value)
MENU
20mA Pt (value)
SPt1 Pt (value)
SPt2 Pt (value)
access Sensor
Menu (Top Menu)
Run
Mode
set value with
or
Save setting
and return to
Quick Menu
Cancel and
return to
Quick Menu
* In Setpoint Mode,
SPt1 Pt is replaced by SPt
and SPt2 Pt is not available.
Figure 7. Quick Menu Map (Window Mode)
Sensor Menu (MENU)
Access the Sensor Menu by pressing Enter from Run mode. The Sensor Menu is also accessible from the Quick Menu: navigate to
MENU and press Enter . The Sensor Menu includes several submenus that provide access to view and change sensor sengs and to
view sensor informaon.
L-GAGE
®
LTF Time of Flight Laser Distance Sensor
4 www.bannerengineering.com - Tel: [phone] P/N 194136 Rev. D