User's Manual

DX80 Quick Start Guide
P/N 128185
Banner Engineering Corp. • Minneapolis, MN U.S.A.
www.bannerengineering.com • Tel: [phone]
6
GETTING STARTED – VERIFY COMMUNICATIONS
Verify LED 1 is ON Green.
Verify LED 1 is flashing Green. LED 2 is off. Until communication is established with
the Gateway, the Node’s LED 2 flashes Red. When communication is established, the
Node’s LED 1 flashes Green.
LED Status LED 1 LED 2
Green ON Power ON —
Green FLASHING — —
Red ON System Error RS485 Error
Red FLASHING — RS485 Fault
Yellow FLASHING — RS485 Active
Gateway
LED Status LED 1 LED 2
Green ON — —
Green FLASHING RF Link OK —
Red ON System Error System Error
Red FLASHING — No RF Link with
Gateway
(out of sync)
Node
Quick Start: STEP 4
> Verify Communications, Gateway
> Verify Communications, Node