User Manual

10 97233 v.3.0
Flash
Code
PDA Error Message Corrective Action- LBZ/ LMM
1.1 Code 11: VGT control input out
of range
Turn ignition OFF and check the 24-Pin connector. Turn
ignition back ON and re-check for presence of code.
1.2 Code 12: Vane Position Sensor
input out of range.
Turn ignition OFF and check the 24-Pin connector. Turn
ignition back ON and re-check for presence of code.
1.3 Code 13: Rear wheels slipping None required. When traction is regained, error will clear after
30 seconds.
1.4 Code 14: Low power voltage
detected.
Turn ignition OFF and check the Fuse Tap and the Ground
O-ring. Turn ignition back ON and re-check for presence of
code.
2.1 Code 21: VGT control output
malfunction.
Turn ignition OFF and check the 24-Pin connector. Turn
ignition back ON and re-check for presence of code.
2.2 Code 22: VGT control output
overcurrent.
Turn ignition OFF and check the 24-Pin connector. Turn
ignition back ON and re-check for presence of code.
2.3 Code 23: Low relay voltage
detected.
Turn ignition OFF. Turn ignition back ON and re-check for
presence of code.
2.4 Code 24: Vane Position Sensor
voltage output malfunction.
Turn ignition OFF and check the 24-Pin connector. Turn
ignition back ON and re-check for presence of code.
3.1 Code 31: OBD communication
error.
Turn ignition off and check the OBD connector and cable. Turn
ignition back ON and re-check for presence of code.
3.2 Code 32: Internal module
malfunction or intermittent
power.
Turn ignition OFF. Turn ignition back ON and re-check for
presence of code.
3.3 Code 33: OBDII CAN
communication output error.
Turn ignition OFF and check the 16-Pin C100 Intercepting
connector. Turn ignition back ON and re-check for presence
of code.
3.4 Code 34: OBDII CAN
communication input error.
Turn ignition OFF and check the 16-Pin C100 Intercepting
connector. Turn ignition back ON and re-check for presence
of code.
4.2 Code 42: Torque Converter
Clutch slippage detected.
Turn ignition OFF and check the 16-Pin C100 Intercepting
connector. Turn ignition back ON and re-check for presence
of code.
4.3 Code 43: Shift control
malfunction.
Turn ignition OFF and check the 16-Pin C100 Intercepting and
20-Pin connectors. Turn ignition back ON and re-check for
presence of code.
4.4 Code 44: Internal memory
malfunction.
Turn ignition OFF. Turn ignition back ON and re-check for
presence of code.
Table 1
If problem persists, call Gale Banks Engineering Tech Support.