User Manual

97227 v.7.0 17
5. Find the Banks OBD II Interface
Cable in your kit. Connect the Banks
Interface Cable to the vehicle’s OBD II
connector. Use a cable tie, as shown
in Figure 17, to secure the Banks
Interface Cable to the vehicle’s OBD II
connector.
6. Next, connect the 6-terminal
connector on the Banks OBD II
Interface Cable to the 6-pin connector
on the Banks SpeedBrake wire
harness.
NOTE: If your vehicle is equipped with a
Banks Diesel Tuner, Optional Tuner-to-
SpeedBrake cable will be needed (P/N
55411). See Figure 18. Disconnect the
6-pin terminal connections between
Banks OBD II Interface Cable and Banks
Diesel Tuner. Connect the OBD II 6-pin
male connector to the optional Tuner-
to-SpeedBrake 6-pin female connector.
Connect the three (3) wire 6-pin male
connector to the SpeedBrake female
Figure 15
Figure 16
Fuse Access
Panel