User guide

96815 v.3.0 31
If the Six-Gun Diesel Tuner should ever
need to be removed from the vehicle,
perform the following:
1. Disconnect the Six-Gun’s 38-pin
connector from the factory harness.
2. Re-connect the vehicle’s 38-pin
connector back into the factory
harness.
3. Disconnect the Six-Gun’s 24-pin
connector from the factory harness.
4. Re-connect the vehicle’s 24-pin
connector back into the factory
harness.
5. Disconnect the 2-ring terminals
from the EGT thermocouple.
6. Disconnect the 3 small connectors
on the ‘In-Cab Cable’ and gently pull
the cable back through the firewall.
7. Remove the Six-Gun Diesel Tuner.
Failure to follow the above instructions
when removing the module will result
in a “Check Engine” light on the dash
and a Diagnostic Trouble Code being
stored in the factory computer, in
addition to the engine not running.
-END, SECTION 10-
Section 10
REMOVAL OF THE SIX-GUN DIESEL TUNER
✁
Figure 20