User guide
24 96815 v.3.0
NOTE: Please refer to the Banks iQ 
Software & Installation Kit, Owners 
Manual for software installation and 
operation instruction before beginning 
Section 6, Automatic Transmission 
Learning
The 6.6L Chevy Duramax Trucks 
equipped with the Allison 1000 
5-speed automatic overdrive 
transmission use an adaptive shift 
control logic. This will require the 
transmission to adapt to the additional 
power created by the Banks Power 
products before it will shift properly. 
Failure to follow the sequence can 
result in damage to the transmission.
Perform the following sequence 
at a location where it is safe to 
accelerate without exceeding the 
posted speed limit.
1. Set Six-Gun to level one power 
setting, start the truck and allow the 
engine to reach normal operating 
temperature.
2. Adjust Six-Gun to level two, power 
setting.
3. Drive vehicle for 5 to 10 miles 
ensuring a complete shift cycle though 
each gear. (The transmission shift 
adaptation learning process requires 
15 to 30 complete shift cycles to learn 
new shift program.)
4. Increase power level by one and 
repeat Step 3 until the desired power 
level is achieved.
WARNING: Take particular care not 
to do wide open runs in 5th gear 
when in Automatic transmission 
Learning Mode, especially if speed 
loader is installed.
The Allison 1000 5-speed automatic 
transmission will continually adapt 
to the power output of the engine 
to optimize shift quality. The 
transmission will quickly adapt 
to the power setting if the 
driving cycle includes regular 
gear changes at high loads. The 
transmission learning procedure 
will need to be repeated when 
switching back to the higher 
power settings once the 
transmission adapts to the lower 
power settings. It will be apparent 
when the transmission adapts to the 
lower settings by monitoring the feel 
of the gearshift. Gear changes will 
be noticeably harder when initially 
switching from a higher to lower 
power setting. This will soften as 
the transmission adapts to the new 
setting.
-END, SECTION 5-
Section 5
AUTOMATIC TRANSMISSION LEARNING










