User guide

ManualsBrandsBanks Power ManualsCarChevy_GMC Trucks: Duramax LB7 (Diesel ’01 - 04 6.6L) Tuner- Six-Gun Diesel Tuner w_ optional Speed-Loader Module (LB7 & LLY) '01-05 (iQ) Compatible with Optional Banks iQ

20 96815 v.3.0

washer and nut. Snug the washer; be

careful not to over torque the nut and

damage the plastic threads.

7. Install the knob onto the shaft

facing the #1 Level on the Six-Gun

label. On the knob, snug the two (2)

set screws with the supplied 0.050”

hex key wrench.

8. Route the Six-Gun Switch cable

down to the Six-Gun Diesel Tuner’s

three-connector cable underneath the

dashboard, and reinstall the IP to the

dashboard.

9. Connect the Six-Gun Switch Cable’s

2-pin receptacle to the 2-pin plug on

the Six-Gun Diesel Tuner’s grey three-

connector cable.

WARNING: if excessive torque

converter slip is detected then

a Limp Home Mode override will

be set by the ECU. This LHM will

be active until torque slippage is

no longer detected or is reset by

Diagnostic Tool.

-END, SECTION 3-

Figure 13