Manual

ManualsBrandsBanks Power ManualsCarChevy_GMC Trucks: Duramax LB7 (Diesel ’01 - 04 6.6L) Speed Control- Compressor Relocation Kit Required for Ram-Air Intake System

10/22/06 PN 96978 v.2.0

Banks Compressor

Relocation Kit

Banks Brake System

FOR USE WITH P.N. 55234

Gale Banks Engineering

546 Duggan Avenue • Azusa, CA 91702

(626) 969-9600 • Fax (626) 334-1743

Product Information & Sales: (888) 635-4565

Customer Support: (888) 839-5600

Installation Support: (888) 839-2700

bankspower.com

InstallGuide

Summary of content (8 pages)

PAGE 1
InstallGuide Banks Compressor Relocation Kit Banks Brake System FOR USE WITH P.N. 55234 Gale Banks Engineering 546 Duggan Avenue • Azusa, CA 91702 (626) 969-9600 • Fax (626) 334 -1743 Product Information & Sales: (888) 635-4565 Customer Support: (888) 839-5600 Installation Support: (888) 839-2700 bankspower.com ©2006 Gale Banks Engineering 10/22/06 PN 96978 v.2.
PAGE 2
Installation Instructions This instruction sheet is for the installation of the Banks Brake compressor to its new location. The relocation of the Banks Brake compressor is necessary when installing the Banks High Ram Intake System. After completing the compressor relocation instruction proceed to the Banks High Ram Intake System owners manual for additional instructions. 1. Disconnect both grounds from driver and passenger side battery. fastened to the bus bar.
PAGE 3
Figure 2 Figure 3 96978 v.2.
PAGE 4
Note: Leave the remaining (2) rubber isolator attached to the compressor. 10. Refer to Figure 2 to identify which electric solenoid valve is used. 11. If the style I electric solenoid is being used then see Figure 4a for reassembly reference. If the style II electric solenoid is being used then see Figure 4b for reassembly reference. 12. Locate the retrofit compressor panel. 13.
PAGE 5
Figure 5 Figure 6 96978 v.2.
PAGE 6
need to be shortened to fit properly in the new mounting location). 19. Locate the inner fender brace on the top left of the engine compartment. See Figure 5. Remove the fender brace four (4) bolts and then set aside. 20. Remove the connector attached to the engine firewall by pulling off the plastic retainer. Note: The connector is being relocated to provide clearance for the brake compressor panel. 21.
PAGE 7
Figure 8 28. Reconnect the power wire from the Banks air compressor to the bus bar. 29. Reconnect the battery grounds to both batteries. 30. You have now completed the relocation of the Banks air compressor to the new location. Proceed to the Banks Ram Air Intake System owner’s manual to complete the installation. 96978 v.2.
PAGE 8
Gale Banks Engineering 546 Duggan Avenue • Azusa, CA 91702 (626) 969-9600 • Fax (626) 334 -1743 Product Information & Sales: (888) 635-4565 Customer Support: (888) 839-5600 Installation Support: (888) 839-2700 bankspower.