Instruction Manual

16. Tighten the Banks Ram-Air filter
housing bolts to vehicle frame.
17. Install the Banks bellows hose
and hose clamp onto the Banks Ram-
Air intake tube.
18. Loosely fit the hose clamp to the
other end of the bellows.
19. Install the Banks Ram-Air cover
into bellows.
20. Install Banks Ram-Air cover w/
filter into the Banks Ram-Air filter
housing.
Note: a slight resistance in pressing
in the Banks bellows is normal.
21. Now with the Banks Ram-
Air filter housing cover and Banks
bellows fully seated flush, fasten the
Banks cover to the Banks housing
using the Banks cover screws and
tighten.
22. Make sure that the Banks
bellows is flush with the Banks cover
connection bead and tighten the
Banks bellows hose clamp.
Note: Bellows will need to be
compressed slightly.
23. Connect MAF sensor connector
to intake tube.
Note: you may have to loosen wire
harness clips, to increase slack in
length of wire harness available to
connect to intake air tube See
Figure 34.
24. Re-install the passenger side
wheel well.
25. You have successfully
completed the installation of the
Banks Ram-Air Intake system. See
Figure 35. Make sure to go over
all hose clamps for tightness and
connectors for a sure fit. Make sure
that the intake tube is not touching
any engine components, specifically
the boost tube and intake manifold
hose clamps.
-END, SECTION 4-
Figure 34
Figure 35
30 96776 v.11.0