Instruction Manual

Tools Required:
•
1
⁄4” and
3
⁄8” drive ratchets
• Inch and metric deep sockets
• Ratchet extension
• Metric combination or open-end
wrenches
• Phillips and flat blade screwdrivers
• Standard and needle-nose pliers
• Pocket or X-Acto knife
• Clean shop towels or rags
• Drill bit set
• Drill motor
• Tap Handle
•
1
⁄4” NPT tap
•
5
⁄16 nut driver
• Pliers
• Torx bits
• Pry-bar
Highly recommended tools and
supplies:
• Multimeter or 12-volt test light
• Heat gun
• Foot-pound torque wrench
• Penetrating oil or light lubricant
spray
• Reciprocating saw
• Inch-pound torque wrench
Table of Contents
General Assembly Diagram ......4
Banks Power Pack System
Section 1 ......................6
Installation of Banks Monster Exhaust
System
Section 2 .....................13
Techni-Cooler Assembly Installation
Section 3 .....................24
Thermocouple Installation
Section 4 .....................25
Banks Ram-Air Intake System
Section 5 .....................31
Banks EconoMind Diesel Tuner
Installation
Section 6 .....................33
Mounting the Docking Station and
Connecting the Banks PowerPDA Vehicle
Command Center
Section 7 .....................35
Installation of the Power Level Selector
Switch
Section 8 .....................38
Optional Gauge Cluster Installation
Section 9 .....................39
Automatic Transmission Learning
Section 10 ....................40
Troubleshooting, EconoMind
Section 11 ....................42
Clearing Learned Parameters
Section 12 ....................42
Updating Your Banks PowerPDA Software
& Banks EconoMind Diesel Tuner
Firmware
Section 13 ....................42
Removal of the EconoMind Diesel Tuner
Section 14 ....................43
Filter Maintenance
Section 15 ....................44
Placement of the Banks Power Decals
96776 v.11.0 3