Instruction Manual

2. Locate your Banks Ram-Air filter
housing from your kit and install as
shown in Figure 27. The cutout on
Banks Ram-Air filter housing must
face passenger side fender. Align
the Banks Ram-Air filter housing
holes with bolt holes in engine
compartment. Install the previously
removed stock air box bolts to
secure the Banks Ram-Air filter
housing. Do not tighten the bolts at
this time.
3. Locate your Banks Torx tool,T20H
in your Banks Ram-Air kit. Use the
Torx tool bit to remove the two (2)
screws securing the MAF sensor to
the stock air box cover.
Note: When removing the MAF
sensor, grasp its body and pull up
and out. Do not twist or bend when
removing.
4. Locate the Banks MAF sensor
o-ring supplied in your kit. Install
Banks o-ring as shown in Figure 28.
Ensure o-ring is flush to MAF sensor
edge as shown.
Note: Retain stock o-ring. Keep stock
o-ring in place, you will be installing
the Banks o-ring while retaining the
original o-ring on the MAF sensor.
Figure 27
Figure 28
96776 v.11.0 27