Instruction Manual

REMOVE STOCK COMPONENTS
1. Make sure the previously removed
ground cables from both batteries
are still disconnected.
2. Disconnect the mass airflow
(MAF) sensor’s connector at the
air box assembly. Note: MAF will
be installed after Ram-Air intake
installation.
Loosen the hose clamp that joins the
inlet air transfer tube to the molded
plastic compressor inlet duct. Pull the
air box out of the vehicle. It’s held in
place by plastic fasteners that snap
in place. Cover the turbocharger inlet
with a clean rag to prevent debris
from entering the turbocharger that
could result in damage upon start-up
3. Remove the air box mounting tray
from the vehicle shown in Figure 8..
If installing a Banks Stinger
System, Skip ahead to Section 3.
4. Remove the upper grill baffle
that mounts between the grill and
radiator cross brace. The baffle is
held in place by 7 push-in retainers.
The retainers are removed by pulling
up on the center pin, then prying the
retainer out of it’s hole as shown in
Figure 9.
Figure 9 Removal of push-in retaining pins
Figure 8 Air box mounting tray
14 96776 v.11.0