Installation guide

Troubleshooting 55
Survey of conguration versions
All edits are done in the Edit version (in non volatile memory which is deleted at power off). When you are editing the Current active version is still
running making sure your are not making black-out in the whole house.
- Use the Test button to test changes made in Edit version. This will copy the Edit version to the Running version.
- Continue to Edit and Test until conguration works as expected.
- Use the Save button when conguration works as expected. This will (1) save previous Current active version in Backup version and (2) save Edited
= Running version in Current active version.
- Use the Cancel button if you want to pause your Edit/Test and return to the Current active version.
- Use the Discard button to delete all your edits and start over again with a new copy of Current active version.
- Use the Previous button to return to the last Backup version and make it Running version.
Note: Current active version and Backup/Previous version are swapped, which makes it easy to test both versions.
- Use the Tools, Conguration, Save conguration to make disk copies of Edit, Current active or Backup versions.
- Use the Tools, Conguration, Load conguration to load one of the saved versions into the Edit version. Remember to use the Test and Save
buttons to make it the Current active version.
Current active
version
Edit
version
Backup/
Previous
version
Disk
storage
Running
version
Test
Save
2
1
Cancel
Save
configuration
Load
configuration
Discard
All edits
Previous 1
Power ON
2