Installation guide

Supported devices 45
Scheduler
A scheduler generates a timed sequence of events. It is possible to dene more than one scheduler for the project.
On the resources screen a series of events for the scheduler must be dened with the following information:
- Event name:
This is the name of the event that will be generated. Use the same name more than once if you want the same event to be produced at different
times.
- Wait time:
This is the number of seconds since the scheduler was started (it is not relative to the previous row).
Schedulers accept 2 commands: start and stop. Starting a scheduler will start to produce events at the set times. Once the last event is generated,
the scheduler automatically restarts (only if the option Continuous is selected).
! Be careful to provide other ways of stopping a scheduler. For example, events from Beo5 or from a keypad.
Smart-House
Connection to a Smart-House system
Connection to a Smart-House system is made via an Ethernet connection to a Smart-House controller. Both the IP address and the TCP port must
be congured on MLGW.
Dening Resources
Resources can be dupline input channels, dupline output channels or functions of type sequence. Interaction between MLGW and the Smart-
House system is implemented via changes in the status of channels and the start / stop of sequences.
Events and commands
Events can be a dupline channel set, a dupline channel reset, a sequence start or a sequence stop. Commands to a Smart-House system are set,
reset or pulse a dupline channel and start or abort a sequence.