User Manual

9
R E A D Y F O R U S E …
When you have checked all the
connections, connect your main
system to the mains – and then
the BeoLink Passive amplifier
box.
Once connected to the mains,
the BeoLink Passive is in stand-
by mode. The amplifier box
switches on and off automati
-
cally, and is designed to be left
in stand-by mode when not in
use.
Normally, the BeoLink Passive
will now be ready for use. How-
ever, in special product setups,
you may need to preprogram
the setup.
The BeoLink Passive can be pre-
programmed for the following
setup situations (Options):
Option 0: To be used if you
want to disable remote con-
trol operation of the BeoLink
Passive (to enable remote
control again, select one of
the other options).
Option 4: To be used if you in-
stall the BeoLink Passive in
the same room as your main
system (e.g. in a large L-
shaped living room with two
separate listening positions).
Option 5: To be used if you in-
stall a TV set in the same
room as you BeoLink Passive.
Option 6: To be used for a setup
with your main system in one
room and the BeoLink Passive
in another, as described in
this guide (this is the factory
setting).
The preprogramming is done
with a Bang & Olufsen remote
control. It must be carried out
with both the main- and the
link system switched to stand-
by!
Using a Beo4:
– Hold the • button while
pressing LIST.
When the Beo4 display reads
OPTION?, press GO.
– Press LIST to display L.OPT
and then key in the appro-
priate number (0, 4, 5 or 6).
Using a Beolink 1000:
– Press LINK, the appropriate
number (0, 4, 5 or 6), and
then STORE.