BeoLab 6002 Guide
WARNING: To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture. Do not expose this equipment to dripping or splashing and ensure that no objects filled with liquids, such as vases, are placed on the equipment. To completely disconnect this equipment from the AC Mains, disconnect the mains plug from the wall socket. The disconnect device shall remain readily operable.
Daily use When you have finished setting up the loudspeakers as described on the following pages, connect the entire system to the mains supply. The indicator lights up in red, indicating that the loud speakers are in standby, ready to be used. The loudspeakers are designed to be left in this standby mode when not in use. Switching on and off – indicator When you switch on your Bang & Olufsen system, the loudspeakers switch on simultaneously.
Set up the loudspeaker 4 We recommend that you follow this procedure: – Disconnect your system from the mains supply. – Place the loudspeakers in your setup. – Set the switches to the correct setting. This is explained in ‘Adapt the loudspeakers to your setup’ (pages 6–7). – Connect your speaker system. – Connect the entire system to the mains again. If you mount the loudspeaker on a wall bracket, you cannot assemble the base to the loudspeaker.
Cable connections The loudspeakers can be used with Bang & Olufsen audio, video and link systems. They may also be used with non-Bang & Olufsen systems. For specific information about the sockets on your system, refer to the Guide enclosed with the system. The socket panel is located at the bottom of the loudspeakers. Power Link connections: These connections carry both the right and left sound signals.
Adapt the loudspeakers to your setup 6 The loudspeakers may be placed almost anywhere in your room. However, the most natural sound is obtained if they are set up as explained on these pages. SETUP switch This switch has three settings: LEFT, RIGHT and LINE. Set the switch to LEFT or RIGHT when connecting the loudspeakers in a Bang & Olufsen system. Set the switch to LINE when connecting the loudspeakers in a non–Bang & Olufsen system.
Position zones: The three settings (CORNER–WALL–FREE) correspond to the position zones marked in different shades of grey. CORNER WALL FREE CORNER Use this setting if the loudspeaker is placed in a corner – shown by the dark grey areas in the illustration. WALL Use this setting if the loudspeaker is placed less than 15 cm (6") from the wall, and no closer to a corner than 50 cm (20") – shown by the grey areas along the walls in the illustration.
Waste Electrical and Electronic Equipment (WEEE) – Environmental protection Electrical and electronic equipment, and waste prevents the potential parts and batteries marked with contamination of nature with the this symbol must not be disposed hazardous substances which may of with normal household wastage; be present in electrical and elec all electrical and electronic equip tronic products and equipment.
Technical specifications, features and the use thereof are subject to change without notice! All Bang & Olufsen products comply with applicable environmental legislation throughout the world. For the Canadian market only! This class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations. For the US-market only! NOTE: This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules.
3510483 Version 1.
