User Manual

RB-Ban-230
Banebots P60 Gearbox: 1.5" Shaft, RS-540/550 Mount, 5:1 (No Grease)
Important Note:
Mounting a large load to the end of an unsupported shaft may damage the
gear motor. The shafts on these motors are supported by two ball bearings
making them fairly rugged; however, Banebots does not recommend them to
be used with large overhung loads. Banebots recommends using a design
that supports the end of the shaft. If it is not possible to support the end of
the shaft, the manufacturer recommends mounting the load as close to the
face of the gearmotor as possible and cutting the shaft to length. Banebots’
1.5 in square, 1/2" shaft bearing block provides a simple and effective way
to support the shaft.