Quick-Start Guide

3
#89843 LX-48
Assembly Diagram
To Assemble:
Identify and Separate all the Parts and Hardware.
A2
Place Leg Upright (P-11) on a flat surface
as shown in illustration # 1.
[ with 2 large holes facing up ]
Attach Upper Leg Mount (P-9) and Lower Leg
Mount (P-10) using 4 each Phillips Screws (A2)
as shown in illustration # 1.
1.
2.
3.
P-11
A2
P-9
P-10
Note: 4 Holes are located near
Upper Leg Mount (P-9) as shown
in illustration # 1
Place the Left Side Panel (P-1) with the Predrilled holes facing up and install 2 Cam Posts (D) in
the 2 threaded insert nuts (Pre-installed) as shown in illustration # 2.
Install 2 Cam Locks (C) in the 2 large holes.
Install 8 Wood Dowels (E) into the holes as shown in illustration # 2.
5.
6.
4.
E
E
P-1
D
E
Illustration # 2
C
P-1
Be sure that arrow on
top of Camlock (C)
aligns with centerline of
Edge Drilled hole.
Phillips
Screwdriver
Centerline of
Edge Drilled
hole.
Arrow
6.
Illustration # 1