23456789012345678901234567890121234567890123456789012345678901212345678901234 123456789012345678901234567890121234567890123456789012345678901212345678901234 123456789012345678901234567890121234567890123456789012345678901212345678901234 123456789012345678901234567890121234567890123456789012345678901212345678901234 123456789012345678901234567890121234567890123456789012345678901212345678901234 123456789012345678901234567890121234567890123456789012345678901212345678901234 12345678901234567890123456789012123456
WOW Split Level 72 Part Drawing P1 P2 P3 Description Monitor Platform Keyboard Platform Upper Insert Task Table Part Qty 1 EA Drawing Description Qty P8 CPU Rail 2 EA P9 CPU Foot 4 EA P10 CPU Platform 1 EA 2 EA 2 EA Hardware List Left Front & Right Back P4 Upper Insert Right Front & Left Back 2 EA P5 Stability Panel 2 EA P6 P7 Crossbrace Leg Receiver 3 EA A M6*15mm Socket Screw 16 EA A1 M6*48mm Socket Screw 14 EA A2 M6*36mm Screw B M6*61mm Socket Screw 8 EA C M6
Split Level 72 Task Table Assembly Diagram READ THROUGH INSTRUCTIONS FROM BEGINNING TO END BEFORE STARTING TO ASSEMBLE UNIT. P4 1.) Identify and Separate all the Parts and Hardware. 2.) Place the Monitor Platform (P1) with the insert nuts facing up. Attach 1 each Upper Insert (P3) and 1 each Upper Insert (P4) using 4 each (B) screws. (Finger tighten only) P6 P3 B P-1 B A1 Illustration # 1 P4 3.
B 5.) Place the Keyboard Platform (P2) with the insert nuts facing up. Attach 1 each Upper Insert (P3) and 1 each Upper Insert (P4) using 4 each (B) screws. (Finger tighten only) P3 A A1 P5 P4 6.) Attach Crossbrace (P6) to the Upper Inserts (P3 & P4) using 2 Screws (A1) as shown in illustration #3. P6 B 7.) Attach Stability Panel (P5) to the Upper Inserts (P3 & P4) using 4 Screws ( A) as shown in illustration #3. Illustration # 3 P2 8.
11.) Place the CPU Platform (P10) with the insert nuts facing up. Attach 2 each CPU Feet (P9) using 4 each (A2) screws. (Finger tighten only) A2 F P9 A2 F P9 12.) Attach 1 each CPU Rail (P8) to the CPU Platform (P10) using 2 each (A1) screws. (Finger tighten only) A1 13.) Attach 2 each Glides (F) to the 2 Feet (P9) as shown in illustration #5. P10 14.) Repeat Steps 11-13 for Second CPU Platform Assembly. P8 Illustration # 5 CPU Assembly P7 15.
16. Press Grommets (E) into the rear table top as shown in Illustration #7. Illustration #7 E 72 19 Adjustable Height 25 ½ - 31 ½ 17 8¾ 8¾ Do not use unless all screws are tight. At least every six months, check all screws to be sure they are tight. If parts are missing, broken, damaged, or worn, stop use of the product until repairs are made by your dealer using factory authorized parts. Important The product you have purchased is guaranteed against material and workmanship defects.
