23456789012345678901234567890121234567890123456789012345678901212345678901234 123456789012345678901234567890121234567890123456789012345678901212345678901234 123456789012345678901234567890121234567890123456789012345678901212345678901234 123456789012345678901234567890121234567890123456789012345678901212345678901234 123456789012345678901234567890121234567890123456789012345678901212345678901234 123456789012345678901234567890121234567890123456789012345678901212345678901234 12345678901234567890123456789012123456
#27544 Platinum LCD Cart Part Drawing P1 Description Left Leg 1 EA P2 Right Leg P3 LCD Tube 2 EA P4 Lower Cross Brace 1 EA P5 Stability Panel 1 EA P6 Left Shelf Bracket 1 EA P7 Right Shelf Bracket 1 EA P8 Wood Shelf 1 EA P9 Rotation Bracket-left 1 EA P10 Rotation Bracket-right 1 EA P11 Adj Bracket-left Part Qty Drawing Description Qty Hardware List 1 EA A Screw M6X13mm 6 EA A1 Screw M8X40mm 4 EA A2 Screw M6X8mm 8 EA B Plastic Washer 2 EA B1 Plastic Bushing
#27544 Platinum LCD Cart Assembly Diagram READ THROUGH INSTRUCTIONS FROM BEGINNING TO END BEFORE STARTING TO ASSEMBLE UNIT. Illustration # 1 1.) Identify and Separate all the Parts and Hardware. 2.) Slide Left and Right Rotation Bracket (P9 & P10) onto 1 LCD Tube (P3) as shown in illustration # 1. P-9 P3 P3 P11 P10 3.) Slide Left and Right Adj Bracket (P11 & P12) onto 1 LCD Tube (P3) as shown in illustration # 1. P12 4.
1 LCD Illustration # 3 5.) Insert 2 LCD Tubes (P3) into the Left and Right Legs (P1 & P2) as shown in illustration # 3. P3 A1 P2 P3 A2 A 6.) Attach Left and Right Legs (P1 & P2) to the Lower Cross Brace (P4) using 4 screws (A1) as shown in illustration # 3. P5 P4 A2 7.) Attach Stability Panel (P5) to the Left and Right Legs (P1 & P2) using 4 screws (A2) as shown in illustration # 3.
Illustration # 5 P-9 10.) Secure Rotation Brackets (P9 & P10) using 2 Clamps (C), 2 Plastic Washers (B), 2 Plastic Bushings (B1), and 2 Threaded Metal Caps (D) as shown in illustration # 5. P3 B P10 B1 C D P11 P12 Illustration # 6 Secure Brackets at desired width by tightening (A) screws using Phillip’s head screwdriver A Tighten (A) & (A1) Screws using Allen Wrench (G). Important The Balt product you have purchased is guaranteed against material and workmanship defects.
