User's Manual

COBALT UHF-SERIES CHAPTER 5: COMMAND PROTOCOLS
PAGE 88 OF 140
0x89
SUBNET RESPONSE
MALFORMED
Internal Subnet Error – a controller
returned a malformed response.
0x8A
SUBNET RESPONSE TIMEOUT Internal Subnet Error – a controller was
unable to generate a response before
timeout was reached.
0x8B
SUBNET RESPONSE INVALID
CHECKSUM
Internal Subnet Error – a controller
generated a response that has an
invalid checksum.
0x8C
SUBNET DEVICE CONFLICT
DETECTED
Internal Subnet Error – a Node ID
conflict has been detected
0x8D
BUFFER OVERFLOW Internal Error – buffer limit was
exceeded
0x8E
FLASH FAILURE Internal Error – flash memory failure
0x92
SUBNET16 ONLY COMMAND A Subnet16-only command was issued
when in MUX32 mode.
0x93
NODE MISMATCH ERROR The Node specified in the command
did not match the Node to which the
command was sent
0x94
CRC ERROR Internal Communications Error
0x95
PROTOCOL ERROR Internal Communications Error
Table 5-19: Error Code Table