User's Manual

COBALT UHF-SERIES CHAPTER 2: INSTALLING THE COBALT UHF
PAGE 31 OF 140
2.3.2 UHF-CNTL-485-02 Cabling Information
The UHF-CNTL-485-02 has one
5-pin, male M12 RS485 connector
located on the
bottom of the Controller’s housing.
Figure 2-6: UHF-CNTL-485-02 Controller - RS485 Connector
Table 2-3: RS485 Connector – Pinout
UHF-CNTL-485-02 CABLING PART NUMBERS
CBL-1480-XX: Cable (5-pin, male M12 to 5-pin, female M12, ThinNet)
CBL-1481-XX: Cable (5-pin, male M12 to 5-pin, male M12, ThinNet)
(XX = Cable Length in Meters)
PIN # DESCRIPTION
1
SIGNAL GND
2
10~30VDC PWR
3
0V (POWER GND)
4
Tx/Rx+
5
Tx/Rx-