User's Manual

COBALT UHF-SERIES CHAPTER 2: INSTALLING THE COBALT UHF
PAGE 27 OF 140
2.2.2 UHF-CNTL-232-02 Cabling Information
The UHF-CNTL-232-02 has one 8-pin, male M12 RS232 connector located on the
bottom of the Controller’s housing.
Figure 2-2: UHF-CNTL-232-02 Controller - RS232 Connector
Table 2-2: RS232 Connector - Pinout
UHF-CNTL-232-02
CABLING PART NUMBERS
CBL-1478: Cable Assembly (8-pin, female M12 to RS232; with 2.5mm DC power
jack, 2m)
CBL-1488-XX: Cable (8-pin, female M12 to bare wire leads)
CBL-1492-XX: Cable (8-pin, right-angle female M12 to bare wire leads)
CBL-1493: Connector (8-pos, straight female M12, field mountable)
(XX = Cable Length in Meters)
PIN # DESCRIPTION
1
10~30VDC POWER
2
0VDC (POWER GROUND)
3
NOT CONNECTED
4
NOT CONNECTED
5
NOT CONNECTED
6
RX
7
TX
8
SGND (SIGNAL GROUND)