User's Manual

COBALT UHF-SERIES CHAPTER 1: GETTING STARTED
PAGE 22 OF 140
To connect the Cobalt UHF controller to the antenna, follow the steps below:

Attach the TNC-Reverse male plug of the controller-antenna coaxial cable to
the TNC- Reverse female connector located on the top of the controller’s
housing.

Attach the N-type male plug of the coaxial cable to the N-type female
connector located in the rear of the antenna’s body.
1.4.6 Optional Mounting Kit for Antenna Installation
Industrial environments where UHF RFID applications are used often entail specific
installation requirements.
The Cobalt UHF Antenna can take advantage of an optional mounting set, providing
an easy and solid installation (P/N: 970103035, Mounting Kit for large size UHF
Antennas).
Figure 1-9:Optional Mounting Kit for Antennas