Service manual

IMI015
To protect CRT, insert a thin piece of cardboard between mask and CRT in the
upper right corner. Insert a thin wide blade screwdriver between the mask and
cardboard insert and pry the mask outward by twisting the screwdriver against
the CRT face.
Remove screws holding the CRT and remove CRT from cabinet. Do Not lift CRT by
the neck.
Reverse removal
procedure to install CRT.
4.6.2 TD12 and TD15 models
Follow chassis removal procedures in section 4.5.2.
Discharge CRT HV anode directly to ground and remove anode lead from CRT. Dis-
connect CRT socket and deflection coil plugs.
On TD12 models - remove screws holding mask to frame and tilt mask upward.
Remove CRT mounting screws and lift CRT out of frame. Do Not lift CRT by the
neck.
On TD15 models - pull mask outward from frame and tilt upward to provide access
to CRT mounting screws. Remove CRT mounting screws and lift out CRT from frame.
Do Not lift CRT by the neck.
4-4