Instructions / Assembly
Á>UÁ¿É¸¿tµ¿>¸¸¸Á>Ug[¿¿£l½½¤¿lu¼l¼¼¿¿N¿¿ÑÑѦL>ggg¦U ¿¿¿¿¿¿w
PREPARATION
ASSEMBLY
Ä
Hardware Used:
1
Screw (7x90x15) x2
Install Front Legs
C
: align the brackets at the top of
each leg with the holes drilled in the inside of the Seat
side rails. Insert and gently tighten 2 Bolts
2
per leg
to secure each bracket to the corresponding side rail.
Once all 4 Bolts are inserted, securely tighten using
the Hex Wrench
5
.
Hardware Used:
3
Screw (4x20) x12
4
Support Bracket x2
Before beginning assembly, be sure to empty contents of carton and make sure all parts are present. If any
parts are missing, please contact Customer Service.
Place all parts on a soft, level surface for assembly. Estimated Assembly Time: 20 Minutes
DO NOT over-tighten hardware! Over-tightening hardware can cause wood to crack.
Attach Backrest
A
: insert the tenon at the bottom of
each side of Backrest into the corresponding mortise
drilled behind the woven section of the Seat
B
as shown.
Insert a Screw
1
through the hole drilled in the inside of
the curve of the Seat and finger-tighten into the Backrest.
Repeat to join the other side. Fully-tighten both Screws
using the Hex Wrench
5
.
B
2
C
Hardware Used:
2
Bolt (6x35x13) x4
3
Install Support Brackets
4
: attach Support Brackets
to the back of each joint where the Backrest meets the
Seat using 4 Screws
3
per Bracket. Insert 2 Screws
3
to secure the pre-installed bracket on the front of each
Backrest side rail to the top of the Seat side rail. Gently
tighten all bracket Screws with a Philips-head
screwdriver, being careful not to over-tighten.
Check that all hardware is securely installed.
Your Costa Rica Chair is ready for use!
4
3
4
3
2