Instructions / Assembly

1
Locate the Backrest
B
and Seat Panel
A
. Place a
Washer
G
on a Bolt
F
. Align the panels as shown.
Insert the Bolt with Washer through the eyelet in the
underside of the Seat Panel and into the hole in the
middle of the bottom of the Backrest.
Tighten using the Hex Wrench, but do not over-tighten.
Hardware Used:
F
Bolt (M6x40)
x1
G
Washer
x
1
2
Attach the Left and Right Panels
C
/
D
to the
assembled seat: Place a Washer
G
on each of 6
Bolts
F
. Align the eyelets on the Left Panel with the
holes in the edge of the Seat Panel as shown, then
insert a Bolt with Washer into each of the 3 aligned
sets of eyelets (1 behind the front panel of the seat,
2 along the side of the seat). Gently tighten using
Hex Wrench without fully tightening. Repeat to
attach the Right Panel.
B
Hardware Used:
3
Secure the Side Panels to the Backrest
B
. Place a
Washer
H
on each of 4 Bolts
G
. Insert a Bolt with
Washer through each of the 4 aligned sets of eyelets.
Hardware Used:
F
Bolt (M6x40)
x
6
G
Washer
x
6
Contact us for assistance: [phone] | www.balkenehome.com
x 6
x 4
F
Bolt (M6x40) x4
G
Washer x4
F
G
G
F
4
ASSEMBLY: CHAIRS
A
F
G
C
D
R1
R1
R1
R1
B