Instructions / Assembly

1
2
Place the Table Frame
B
upside-down on a protected
surface (Bolt holes will be visible near each corner). Place
a Washer
F
on each of 8 Bolts
E
.
Position a Leg
C
at the corner of the
Table Frame as
shown, aligning the eyelets in the top plate of the Leg with
the holes in the Table Frame. Insert a Bolt with Washer
into each of the the aligned sets of eyelets.
Repeat to install remaining 3 Legs.
Tighten Bolts with the Hex Key, but do not over-tighten.
Note: for illustration purposes, the table is shown
upside-down, but this step may be easier to complete
with the table on its side or upright. Place a Washer
F
on each of 4 Bolts
E
. Position the Shelf between the
installed Legs resting against the lower brackets of each
Leg, then insert a Bolt with Washer through each
bracket eyelet and into the threaded holes in the
bottom of the Shelf.
Tighten Bolts with the Hex Key, but do not over-tighten.
hardware used:
E Bolt (M6x20) x4
F Washer x4
hardware used:
E Bolt (M6x20) x8
F Washer x8
Your Ashville Table is fully assembled!
Contact us for assistance: [phone] | www.balkenehome.com
10
x4
Place assembled table upright on a flat, level surface to
ensure that it sits squarely and level on the ground.
Adjust connections if needed, then firmly tighten all
Bolts.
Carefully place the Glass Tabletop
D
on the assembled
Table Frame.
3
E
F
D
ASSEMBLY: TABLE
C
C
A
E
F
x8
A
B