Use and Care Manual

aSSEMBLY
Contact us for assistance: [phone] | www.wtliving.com 5
3
ASSEMBLY TABLE
Attach the round leg support C to the three legs
. using Bolts G ,washers/Spring washers/and nuts I
Tighten all nuts.
Hardware Used: 6-Bolt 6X30mm
6 - Washer, Spring Washer, Nut 6mm
4
4
ASSEMBLY TABLE
Lay the table top A upside down on an even soft clean
. surface.Fix the studs J into the table top,then fit the
three table legs B over the fixed studs J and bolt in
position using washers/Spring washers/and nuts H .DO NOT
OVER TIGHTEN.
Hardware Used:3 - Stud 8x30mm
3 - Washer, Spring Washer, Nut 8mm
3