Installation Sheet
PK.1036 Rev 01(4/17)©2017 Spectrum Brands, Inc.
Installing Privacy Locks with Small Rosettes
ese instructions MUST be used for all rosettes with diameters less
than 2.5˝ and a door thickness of 1-3/8˝ to 1-3/4˝ with a 5/8˝ face bore.
After completing the latch and
backplate installation, a hole for
the privacy button needs to be
drilled.
e rst step is to remove
the alignment bushings and
spindle used for the backplate
installation process.
1
Attach the roses to the
backplates using the rose
retainers and tighten with
the supplied spanner tool.
Use a pencil to mark the
privacy hole location on
each side of the door.
2
rose
rose retainer
spanner
tool
hole
location
To avoid damage, remove
both roses and the latch
before drilling the privacy
holes.
3
marked
hole
location
4
Drill a 1/4” diameter hole
through both sides of the door.
Caution: To assure proper
hole location drill from each
side of the door and not from
one side only.
1/4"
diameter
hole
5
Re-install the latch and
re-attach both roses.
On the inside of the room,
thread the privacy button
into the latch and install the
knobs or levers.
privacy
button