Installation Instructions

TEMPLATE
1. Measure and Prepare door
Measure your door for a backset of 2-3/8" (60mm) or 2-3/4" (70mm).
Refer to the template.
Drilling instructions for door preparation
1. Place desired fold line of template (below) on door edge with centerline
approximately 38" (965mm) from oor.
2. Mark screw hole centers.
3. Where marked, drill 1/8" (3 mm) diameter pilot holes, 3/4" (19mm) deep.
Place knob or lever onto chassis and turn set screw clockwise to secure.
3. Install knob/lever
Secure trim to door with screws.
2. Install Trim
Half Dummy Knob/Lever Installation Instructions
2-3/8" 60mm Fold • Doble • Plier
2-3/4" 70mm Fold • Doble • Plier
Centerline
Ligne médiane
Linea central
47037 / 01
Copyright © 2011 Baldwin Hardware Corporation
www.baldwinhardware.com • Customer Service 1.800.437.7448
Please note: Product
illustrations may differ
from your product.
Installation is the same.
The set screws are pre-installed.
They do not need to be removed
prior to knob/lever installation.
Screw hole
Screw hole
The drilling template must be printed to scale
to ensure correct hole placement. To confirm
correct print scale, the square below must
measure exactly 1" by 1" (25mm x 25mm).
1"
25mm
1"
25mm
1"
25mm
Measure
after printing.