Installation Sheet

H1705.000.00015A
© 2005 BALDWIN HARDWARE CORPORATION, READING, PA, U.S.A.
1
DETERMINE HOLE LOCATIONS &
MARK THE DOOR
For non-prepped
doors: Mark the door
at 38" above finished
floor. Fold the paper
template and tape in
place at the centerline
of the lower 2-1/8"
hole (C). Determine /
Mark the backset &
all other hole
locations per the
purchased style.
For factory prepped
doors: Align template
to existing holes and
mark the lower 2-1/8”
hole (C) and
appropriate door pull
location (D).
SHOWN
ACTUAL SIZE
2
DRILL 2 POINT LOCK &
DEADBOLT HOLES
For non-prepped doors:
Remove the paper template. Using a 2-1/8"
hole saw, bore the deadbolt (A) and 2 point
lock (B & C) holes at the marked locations.
For factory prepped door:
Only drill the lower 2-1/8” hole (C) and skip
to Step 6.
3
DRILL EDGE HOLES FOR LATCH
& DEADBOLT
Using the 1" spade bit, drill into the door
edge at the marked locations.
** Do not drill into lower 2-1/8” hole (C) **
See below for depth.
2-3/8" BACKSET: 3-1/2" DEPTH
2
-
3/4"
BACKSET:
3
-
7/8" DEPTH
4
SCORE FACEPLATE CHISEL
GUIDES
Insert the deadbolt and latch assemblies
into the door. Using a utility knife, carefully
score around the faceplates of each
assembly.
5
CHISEL FACEPLATE CAVITIES
Remove the deadbolt and latch assemblies.
Chisel faceplate cavity 5/32" deep.
6
DRILL DOOR PULL HOLE
Drill door pull hole (D) as previously marked
from door template (Step 1).
7
ADJUST LATCH & DEADBOLT
FOR PROPER BACKSET
2-3/4” BACKSET:
Latch: Pull latch hub laterally.
Deadbolt: Twist the faceplate 180°.
8
MOUNT DEADBOLT & LATCH
ASSEMBLIES
Insert deadbolt & latch assemblies into door.
Drill 1/8" pilot holes per faceplate locations.
Secure with (4) #8 combination screws so
faceplates are flush with door edge.
9
INSTALL INTERIOR SIDE TRIM
Mount interior trim. Insert spindle through
latch hub and slide inside mechanism body
over latch case.
LATCH
DEADBOLT
#8-32 x 3/4"
FLAT HEAD
COMBINATION
SCREWS
2.50”
A
B
C
D
A
B
C
A
B
C
(
REFERENCE TABLE
ON TEMPLATE FOR
PROPER DOOR PULL
LOCATION)