Installation Guide

ManualsBrandsBaldwin ManualsHandlesetsBaldwin Blakely Dummy Set Handleset with Egg Interior Knob

Handleset Installation (cont.)

If you have any trouble installing your Baldwin product, feel free to call our toll-free consumer help line at 1-800-566-1986. Hours: 6 a.m. – midnight (east coast standard), 7 days a week.

6Attach handle by inserting

the #10-32 x 2

⁄2" flat head

screw on inside of door

through screw cover backplate

and the lower hole (E). Leave

screw loose for adjustment.

Note: Go to door preparation

if you do not have a lower

hole (E).

7From inside of door, slide

alignment fitting between post

and around latch.

8Measure the thickness of

your door. If door is less than

⁄4" thick, do not use the

spacer provided. If your door

measures 1

⁄4", slide the spacer

onto spindle.

9From inside of door, insert

short end of spindle through

alignment bracket and latch,

with V groove on the long end

angled down and toward hinges.

Position outside handle assembly

so spindle slides into square hole

on thumbpiece cartridge. Make

certain spindle is inserted

through the latch to stops.

10 Slide emergency exit

cartridge onto spindle. Attach

lower cartridge with two #10-

32 x 1

⁄4" flat head screws, but

DO NOT TIGHTEN SCREWS

AT THIS TIME.

inside

inside inside inside

inside

V groove

on bottom

toward

hinges

Spindle