Installation Guide

Handleset Installation
3
1Determine your backset,
which is the distance from
the edge of door to center of
hole. Your lockset is shipped
with a 2
3
8" backset (most
common). Adjust for a 2
3
4"
backset door only.
3Insert latch with angled side of
bolt facing outside. Drill
1
8" pilot
holes. Secure with two #8 x
3
4"
combination screws so latch is
flush with door. Repeat for dead-
bolt.
Helpful Hint: When installing
wood screws it is recommended to
put beeswax or soap on screw
threads to improve installation.
2For a 2
3
4" backset, grasp
body and twist faceplate 180º
until it stops. Angled side of
bolt should face outside.
Follow same procedure for
deadbolt.
Note: See deadbolt orientation
during installation step 4.
4Note orientation of dead-
bolt. Insert deadbolt. Drill
1
8"
pilot holes. Secure with
#8 x
3
4" combination screws so
latch is flush with door.
inside
inside
5Extend deadbolt using
flat head screw driver.
inside
Top
If you have any trouble installing your Baldwin product, feel free to call our toll-free consumer help line at 1-800-566-1986. Hours: 6 a.m. midnight (east coast standard), 7 days a week. 8.