Installation Guide

Fully Dummy Trim Installation
Single Dummy Trim Installation Remember Baldwin
Exploded View Full Dummy Trim
Congratulations!
Drill a 1/2” diameter hole through the
door and countersink both sides 1”
diameter, 1/4” deep.
Center the backplate over the hole.
Mark positions of backplate screws with
the backplate positioned as shown. Drill
pilot holes and tighten screws. Snap on
rose.
Insert the
spindle into the
knob or lever
to the mark for
your door
thickness.
Align the set
screw hole of
the knob or
lever over the
marked side of
the spindle.
Tighten set
screw with the
allen wrench
provided.
Slide the spindle into the hole in the
backplate and out the other side of the
door. The set-screw should be down
and toward the hinges.
Slide the remaining backplate onto the
spindle. Rotate the backplate to take up
any slack. Mark and drill pilot holes.
Tighten screws.
Drill a hole 1” in diameter and 1/4”
deep at the desired position of the
trim- about 40” from the floor or at the
same height as your active trim.
Center the backplate over the hole.
Mark the position of the backplate
screws with the backplate positioned as
shown. Drill pilot holes and tighten
screws. Snap on rose.
Slide the knob or lever onto the spindle and
tighten set screw. The set screw should be
down and toward the hinges.
Rose
Spindle
Backplate
Rose
Set Screw
Set Screw
Exploded View Single Dummy Trim
Rose
Backplate
With your purchase of this solid brass latchset, you’re among a group of
discerning individuals who know the value of selecting the finest – Baldwin.
Our step-by-step installation instructions will help guide you through your
project quickly and easily.
Before you begin your installation, read and understand the installation
instructions and marking templates. If you have any questions, please do not
hesitate to contact our Baldwin Technical Services Department at
1-800-566-1986. We’re here to help!
We thank you for your purchase and wish you the fullest enjoyment of your
Baldwin latchset.
Technical Services Support
1-800-566-1986
Hours: 6am to Midnight C.S.T. - 7 days a week.
© Baldwin Hardware Corporation
P.O. Box 15048 Reading, PA 19612
PK-1056E 3/94
1 2 3 4
5
Snap on the remaining rose. Slide the
remaining knob or lever onto the spindle
and secure with set screw.
6
1
2 3
With the completion of your
project, remember that Baldwin quality
hardware and giftware products are
available for all your decorating and
remodeling needs. Matching entrance sets
for exterior doors, beautiful bath
accessories, and a complete selection of
cabinet and door-enhancing hardware are
all available from your Baldwin retailer.
PK-1056E (3/94)
Interior Latchset
Installation Instructions
BALDWIN
®
.
B
a
l
d
w
i
n
.
G
u
a
r
a
n
t
e
e
d
F
o
r
L
i
fe
.
Dummy Trim Installation
.
B
a
l
d
w
i
n
.
G
u
a
r
a
n
t
e
e
d
F
o
r
L
i
fe
.
For
1-3/8”
thick
doors
For
1-3/4”
thick
doors
Set Screw
V-Groove
Set Screw
1” dia. x 1/4” deep
®