Installation Guide

Template
Bore 7/8” dia. hole
Drill 1/8” dia.
pilot holes for
#8 screws.
Outside Adapter
Passage Spindle
Emergency Release Key
(Privacy Only)
Inside Adapter
Face Plate
Threaded Stud
Rose
Threaded Stud
Set Screw
Privacy Spindle
(Privacy Only)
Privacy Button
(Privacy Only)
Exploded Views Passage and Privacy Latchsets
Preparing the Latchbolt
Door Preparation-Passage and Privacy Latchsets
Strike Installation and Preparation
Passage and Privacy Latchset Installation
Fold the template on the line and locate
on door at desired height (about 40” from
the floor). If the door is beveled, place
folded edge on low side of bevel as
shown in illustration. Mark door.
If you have purchased a privacy set, the
latchbolt should be installed so that the
threaded stud is on the inside (or locking) side
of the door. The curved side of the latchbolt
must face the jamb. The latchbolt can be
reversed by pulling the bolt out, rotating it one
half turn, and releasing.
Caution: Re-check bore hole locations
before drilling. Drill the face bore and
edge bore as indicated on template.
Insert the latch into the edge of the door.
Trace an outline of the faceplate onto the
door edge. Mark and drill screw hole
centers with 1/8” drill.
Chisel out the area marked in step 3 to a
depth of 5/32” or until faceplate is flush
with door edge. You may now proceed
to Strike Installation.
Snap roses onto adapters. For a privacy set, make sure the privacy
hole in the roses are towards the edge of door. Screw in the
privacy button.
Insert the
spindle into the
knob or lever to
the mark for
your door
thickness. Align
the set screw
hole of the knob
or lever over the
marked side of
the spindle.
Tighten set
screw with
allen wrench
provided.
Slide the remaining knob or lever onto the spindle. The set screw
should be down and toward the hinges. Tighten set screw.
1
2
3 4
4
Install the outside adapter and tighten the screws.
3
Install the inside adapter.
To determine the inside adapter: When the adapters are put
together, the outside adapter fits within the inside adapter.
2
2
3
1
5
7
Rotate the spindle so the V-groove is down and toward the hinges.
Push the spindle into the latch and out the other side.
6
Using the strike portion of the marking
template, locate and mark strike
mounting screws and centering
points for your door thickness.
Align the strike and trace outline
onto the door frame using mounting
screw marks for location.
At screw marks, drill two 1/8” dia. pilot holes for the screws.
Bore 7/8” dia. x 3/4” deep hole.
Slide the latch into the door as shown (or locking) side of door. For
a privacy set, the threaded stud should be on the inside. Slide the
face plate over the latchbolt and secure with two wood screws.
1
5
Chisel area marked in step 2 until
strike is flush with the door frame.
Install strike.
You may now proceed to Latchset
Installation.
4
Passage and Privacy Latchset Installation
You have selected one of the latchset types illustrated in these instructions. The exploded
views show, at a glance, how your latchset is assembled. Please follow the step-by-step
installation instructions to ensure proper installation.
Outside Adapter
Privacy Button
Set Screw
Set Screw
V-Groove
V-Groove
For
1-3/8”
thick
doors
For
1-3/4”
thick
doors
Inside Adapter

Summary of content (2 pages)