Specifications
Output Contacts:
Run/Fault Relay
Start/Stop Switch:
Main Speed Potentiometer:
Diagnostic LEDs:
J4: 1X or up to 2X
J9: Normally Open or ClosedJ11: I t Overload selection.
CON1: Used to connect
optional accessories to the drive.
See Appendix, on page 26, for On/Off AC Line Switch connections.
Stop Contact selection.
Torque selection.
J10: Constant or Variable
J7: Regenerative or
Output Relay Operation selection.
Injection Braking selection.
J8: "Run" or "Fault"
J6: Fixed or Adjustable Boost selection.
Rated Motor RPM Operation selection.
Motor Operation selection.
J5: 60 Hz or 50 Hz
All jumpers and trimpots are shown in factory set positions.
J1: AC Line Input Voltage selection
J2: Motor Horsepower selection.
(Catalog Nos. ID5601, ID5602).
J3: Automatic Ride-Through
or Manual Restart selection.
2
Adjustable Trimpots.
JOG Terminal.
See Section 6.6, on page 18.
See Section 6.7, on page 18.
See Section 6.4, on page 17.
See Section 6.4, on page 17.
See Section 6.5, on page 18.
See Section 6.1, on pages 16 – 17.
See Section 6.2, on page 17.
See Section 6.3, on page 17.
See Section 12, on pages 22 – 25.
See Section 12.9, on page 25.
2
see Section 5.5,
see Section 5.8,
on pages 15 – 16.
on pages 14 – 15.
Normally Closed
Red
Normally Open
Relay Common
see Section 5.4, on page 14.
Black
White
See Section 6.10, on page 18.
See Table 2, on page 8.
See Section 6.8, on page 18.
See Section 6.9, on page 18.
White (Low) (P1)
Violet (High) (P3)
Orange (Wiper) (P2)
see Section 11, on pages 21 – 22.
STATUS
POWER
STOP
NCNO COM
FWDCOM RUN REV COM
CON3 CON2
JOGP1P3 P2
ACCELMINMAX JOGCLDECEL BOOST
TB2
MA
J3
2X
J4
50Hz
J5
60Hz 1X
J8J9
NCNOF
J11 J10
CT21VT
CON1
FIX
J6
RGR INJ
J7
ADJ
A
J
2
E
C
D
B
COMP
9
FIGURE 2 – CONTROL LAYOUT
1
Notes: 1. Layout of Catalog No. ID5601 varies slightly. 2. Jumper J2 on Catalog No. ID5601 is labeled “1”, “3/4”, “1/2”, “1/4”, “1/8” (factory set to the “1” position). Jumper J2 on Catalog No. ID5602 is labeled “2”, “1
1
⁄2”, “1”, “3/4”, “1/2”
(factory set to the “1
1
⁄2” position). Jumper J2 on Catalog Nos. ID5203, ID5403, ID5405 is labeled “A”, “B”, “C”, “D”, “E” (factory set according to Table 4, on page 10.