Specifications

2-2 General Information MN715P
Safety Notice:
This equipment contains voltages that may be as great as 1000 volts!
Electrical shock can cause serious or fatal injury. Only qualified personnel
should attempt the start–up procedure or troubleshoot this equipment.
This equipment may be connected to other machines that have rotating parts
or parts that are driven by this equipment. Improper use can cause serious
or fatal injury. Only qualified personnel should attempt the start–up
procedure or troubleshoot this equipment.
PRECAUTIONS:
WARNING: Do not touch any circuit board, power device or
electrical connection before you first ensure that power has
been disconnected and there is no high voltage present from
this equipment or other equipment to which it is connected.
Electrical shock can cause serious or fatal injury. Only qualified
personnel should attempt the start–up procedure or
troubleshoot this equipment.
WARNING: Be sure that you are completely familiar with the
safe operation of this equipment. This equipment may be
connected to other machines that have rotating parts or parts
that are controlled by this equipment. Improper use can cause
serious or fatal injury. Only qualified personnel should attempt
the start–up procedure or troubleshoot this equipment.
WARNING: Do not use motor overload relays with an automatic
reset feature. These are dangerous since the process may
injure someone if a sudden or unexpected automatic restart
occurs. If manual reset relays are not available, disable the
automatic restart feature using external control wiring.
WARNING: This unit has an automatic power up start feature
that will start the motor whenever input power is applied and a
RUN (FWD or REV) command is issued and maintained. If an
automatic power up start of the motor could cause injury to
personnel, this feature should be turned off.
WARNING: Be sure the system is properly grounded before
applying power. Do not apply AC power before you ensure that
grounds are connected. Electrical shock can cause serious or
fatal injury.
WARNING: Do not remove cover for at least five (5) minutes
after AC power is disconnected to allow capacitors to discharge.
Electrical shock can cause serious or fatal injury.
Continued on next page.