User manual

30 Modbus RTU MN744
Message Display Description
PARAMETERS_LOCKED Parameter are momentarily locked
PHASE_SEARCH_RUNNING Phase search is in progress
READ_ONLY Parameter is read only
REALTIME_CLOCK_FAILURE Realtime clock hardware failure
REGISTER_READ_ONLY Register is read only
REMOTE_DOWNLOAD_IN_PROGRESS A Mint file is currently being downloaded to a remote node.
REMOTE_DRIVE_DISABLED The remote drive is disabled (CANopen).
REMOTE_DRIVE_FAULT The remote drive is in fault mode (CANopen).
REMOTE_DRIVE_MOVE_FAILED The remote drive failed to accept the new move (CANopen).
REMOTE_EE_FAIL Problem writing to EEPROM on node
REMOTE_ESTOP_ACTIVE Node in ESTOP condition
REMOTE_MODE_NOT_PROGRAMMED Remote mode is not programmed
REMOTE_STATE_INCORRECT Transaction aborted due to nodes state.
REMOTE_SYNC_ERROR Node reported a synchronous error
SERIAL_ERROR Problem with RS232 or RS485 port.
SINGLE_TERMINAL_ONLY A single terminal is required
STATIC_DATA_OVERRUN Static filled, but data remains.
STATIC_DATA_UNDERRUN Data consumed, but static not filled.
TABLE_ERROR Bad Spline or cam table info
TERMINAL_BUFFER_EMPTY Terminal Buffer is empty
TERMINAL_BUFFER_FULL Terminal Buffer is full
TERMINAL_OUT_OF_RANGE Port value is out of range
TERMINAL_UNAVAILABLE No terminal device
TOO_MANY_TASKS Too many tasks in Mint program
TRANSFER_IN_PROGRESS A parameter table transfer is already in progress
TRANSFER_NOT_READY Drive has not been prepared for parameter table transfer
TYPE_NOT_SUPPORTED type of node not supported
UNDEFINED_TERMINAL Terminal is not defined
UNKNOWN_BBP_ERROR Unknown BBP error code
USB_BABBLE_ERROR USB Babble Error
USB_BIT_STUFFING_ERROR USB Bit Stuffing Error
USB_DATA_CRC_ERROR USB Data CRC Error
USB_NAK_RECEIVED USB Sent or Received a NAK
USB_OVERFLOW_ERROR USB Overflow; the received packet was larger than available buffer space
USB_PACKET_UNEXPECTED USB Packet is not of the expected type
USB_PID_ENCODING_ERROR USB PID Encoding Error
USB_PID_UKNOWN USB PID Unkown
USB_SENT_EMPTY_PACKET USB Sent Empty Packet (ISOCHRONOUS MODE ONLY)
USB_SENT_STALL USB Sent Stall; a token was received but the endpoint was stalled
USB_SYNC_ERROR USB Sync Error
USB_TIME_OUT_ERROR USB Time-Out Error
USB_TOKEN_CRC_ERROR USB Token CRC Error
USB_UNEXPECTED_EOP USB Unexpected End of Packet
USB_WRONG_TIGGLE_BIT USB Wrong Toggle Bit in the DATA PID; data was ignored
VALUE_OUT_OF_RANGE data specified out of range
VARIABLE_NOT_FOUND Static variable not found.
WRONG_NODE_TYPE node referenced not expected type
WRONG_PLATFORM Not available on this controller