User manual

Modbus RTU 29MN744
Message Display Description
INVALID_INPUT digital input out of range
INVALID_LOCAL_NODE Local CAN node not correct.
INVALID_MASTER_CHANNEL Master Channel invalid for Axis.
INVALID_MINT_COMMAND The Mint command is invalid
INVALID_MODE invalid error action mode
INVALID_NODE_ID CAN node number out of range
INVALID_NUM_CAP_PTS Invalid number of capture points
INVALID_OUTPUT digital output out of range
INVALID_PLATFORM_CODE The image files platform is invalid
INVALID_POINTER addresses area outside memory
INVALID_REGISTER_ADDRESS An invalid Modbus register address received
INVALID_REMOTE_BAUD Node doesn't support baud rate
INVALID_STATIC_CHUNK Invalid chunk specified for static.
INVALID_STATIC_HANDLE Invalid handle for static variable.
INVALID_SUBFUNCTION_CODE Received Modbus Invalid Sub-function code
INVALID_TERMINAL_ADDRESS Address type for terminal is not valid
INVALID_TERMINAL_DEVICE Device for terminal is not valid
INVALID_TERMINAL_PORT Port type for terminal is not valid
INVALID_VAR_TYPE Invalid variable type for RemoteObject.
KNIFE_AXES_NOT_CONFIGURED The axes for knife control not set
KNIFE_HANDLER_NOT_INSTALLED Need a KNIFE handler for knife control
KNIFE_ROTATION_OUT_OF_RANGE Knife rotation out of range
MB_INVALID_BLOCK_ERROR Invalid Modbus blocknumber
MINT_PROGRAM_RUNNING A Mint program is already running
MML_ERROR syncronous MML error
MML_NOT_SUPPORTED MML does not support this function
MODE_INVALID_STATUS Drive mode prevented action being taken
MOTION_ERROR general motion (async) error
MOTION_IN_PROGRESS action denied when axis in motion
MOVE_BUFFER_FULL Move buffer is full
MOVE_BUFFER_NOT_EMPTY Move buffer is not empty.
NETWORK_MODE Must be in network mode to perform this operation
NO_BBP_TRANSACTION_REQUESTE No BBP transaction requested.
NO_CONNECTION No Connection Exists
NO_FREE_CAN_OBJECTS There were no free message objects left in the CAN controller.
NO_INPUT_SPECIFIED op on home/limit etc with no i/p
NO_OUTPUT_SPECIFIED op on enable output with no o/p
NODE_NOT_LIVE node is not LIVE
NON_VOLATILE_MEMORY_ERROR Problems with non-volatile memory
NOT_NETWORK_MASTER Must be master of network
OBJECT_NOT_FOUND Application data object not found
OFFSET_PROFILE_ERROR The Offset cannot be Profiled
OPIONAL_CARD_NOT_INSTALLED Option card not installed or defective
OSCOPE_ACTION_DENIED An invalid o-scope command was received during data capture
OSCOPE_NOT_CONFIGURED O-scope has not been configured to allow this operation
OUT_OF_MEMORY not enough heap for operation
OUTPUT_FAULT Fault on the digital outputs.
OUTPUT_IN_USE Output is already in use.
PARAMETER_ACCESS_CONFLICT Two devices updating same parameter
PARAMETER_MODE_ERROR Parameter cannot be changed
PARAMETER_TABLE_DOWNLOAD Can't download Parameter Table.
PARAMETER_TABLE_INDEX Parameter index is out of sequence
PARAMETER_TABLE_PLATFORM Parameter Table doesn't match platform
PARAMETER_TABLE_VERSION Parameter Table version not supported