User manual

22 Modbus RTU MN744
Parameter Support Continued
Parameter Configuration
(Sub-Code 2) Continued
Byte 26: Units
0 List Parameter (no units)
1 Gain or pure number (no units)
2 Bit Field (no units)
3 Volts (V)
4 Current (A)
5 Revolution/Minute (RPM)
6 Hertz (Hz)
7 Kilowatt (KW)
8 Watts (W)
9 Deg C
10 Amps/Volt
11 Percent (%)
12 Newton-Meters (NM)
13 Seconds (SEC)
14 Minutes (MIN)
15 Hours (HR)
16 Ohms (OHM)
17 Henrys (H)
18 Horse Power (HP)
19 Pulses/Revolution (PPR)
20 Counts (CNT)
21 Webers (Wb)
22 Revolutions (REV)
23 Days (DAY)
24 Months (MTH)
25 Years (YR)
26 Hz/sec
27 RPM/sec
28 Degrees
29 Milliamps (mA)
30 Megawatts (MW)
31 Kilowatt Hours (KWH)
32 Megawatt Hours (MWH)
33 Cost/KWH ($/KWH)
34 Cost $
35 Custom Units (read parameter number 3203, Units of Measure)
Byte 27: Data Type
0 IEEE 32-Bit Floating Point Number
1 Unsigned 32-Bit Integer
2 Signed 32-Bit Integer
3 Hexadecimal 32-Bit Integer
4 Binary 32-Bit Integer
5 Packed 4 character ASCII 32-bit Integer (8 bits/character)
Bytes 28-31: IEEE 32-Bit Floating Point Number Scale Factor (EE units->Internal Units)
Byte 32-35: Current Value
Bytes 36-39: Maximum Value
Bytes 40-43: Default Value
Bytes 44-47: Minimum Value